ENGLISH 简体中文 日本語 한국어  

    로그인 | 회원가입 


   
 
키워드나 부품번호를 입력해주세요    



MAX2557A
멀티밴드, 멀티모드 RF-to-Bits CDMA Femto 기지국 무선 수신기

디지털 인터페이스가 내장된 1x/EVDO cdma2000 애플리케이션을 위한 업계 최초 Femto 기지국 칩셋


  QuickView     기술 자료     주문 정보     추가 정보     사용자 의견 (0)     전체  
상태
구매 가능: 생산 중

제품 설명
전체 데이터 시트 요청
The MAX2557A is a complete direct-conversion RF-to-bits receiver for cdma2000® 1x/EVDO femto basestations in Band Classes 0 and 1. The device has dedicated receive paths to enable monitoring forward link activities in both bands.

The unique RF-to-bits architecture of the MAX2557A integrates four LNAs with inputs/outputs internally matched to 50W, quadrature mixers, baseband anti-aliasing filters, programmable-gain RF and baseband amplifiers, fractional-N RF synthesizer, RF VCO, fractional-N frequency synthesizer for ADC sampling clock, and high-dynamic-range I/Q continuous-time sigma-delta ADCs. The sigma-delta modulators perform I and Q analog-to-digital conversion onto 1-bit digital streams. A programmable LVDS-like interface, with its own frac-N clock generation system, is used for the data transfer to the baseband/DSP, where the final decimation, equalization, and digital channel filtering are performed in compliance with the MAX-PHY digital section definition. Digital IP blocks are available from Maxim. The MAX2557A modes of operation are programmable by a 3-wire serial bus.

The MAX2557A is specified for operation in the extended -40°C to +85°C temperature range and is available in a 7mm x 7mm x 1.4mm fcLGA package with exposed pad (EP).

주요기능   애플리케이션/용도
  • Complete RF-to-Digital-Bits Radio Receiver Subsystem
  • Supports
    • cdma2000 1x/EVDO Band Class 0 and 1 Reverse Link
    • cdma2000 1x/EVDO Band Class 0 and 1 Forward Link Monitoring
  • TS25.104 Compliant
  • Compatible with UMTS1900, UMTS850, and CDMA Interference Environments
  • High-Dynamic-Range Continuous-Time Sigma-Delta ADCs Allow Simple AGC Implementation with Switched Gain States
  • MAX-PHY Digital Rx Interface with Single-Bit I/Q Bitstream, No Analog Signals
  • On-Chip Fractional-N Frequency Synthesizers for LO and Sampling Clock Generation
  • Dual-Buffered Reference Outputs to Drive Transmit IC and Baseband DSP
  • Programmable Rail-to-Rail GPO Pins Controlled by Serial Interface for External Component Control
  • Operation Controlled Entirely by 3-Wire Serial Interface, No Analog Control Signals Necessary

 
  • cdma2000 1x/EVDO Femto 기지국

다이어그램
MAX2557A: Pin Configuration/Block Diagram
>핀 구성/기능 다이어그램

필요한 것을 찾지 못하셨나요?
  • 익일에 제공되는 애플리케이션 엔지니어의 제품 선택 조언
  • 파라메트릭 검색
  • 애플리케이션 도움말
  •  QuickView   기술 자료   주문 정보   추가 정보  
     제품 설명 
     주요기능 
     애플리케이션/용도 
     주요 사양 
     다이어그램 

     데이터 시트 
     애플리케이션 노트 
     디자인 가이드 
     Engineering Journal 
     신뢰성 보고서 
     소프트웨어/모델 
     EV 킷 

     가격 및 재고 유모 
     샘플 
     온라인 구매 
     패키지 정보 
     Lead-Free 정보 

     관련된 제품군 
     참고 사항 
     EV 킷 

    문서 레퍼런스 19-4992; 개정판 0; 2009-11-12
    이 페이지는 최근에 변경됨: 2009-11-12


            •         •         •     개인정보보호 정책     •     법적 고지

        Copyright © 2009 by Maxim Integrated Products