The DS2482-800 is an I²C to 1-Wire® bridge device that interfaces directly to standard (100kHz max) or fast (400kHz max) I²C masters to perform bi-directional protocol conversion between the I²C master and any downstream 1-Wire slave devices. Relative to any attached 1-Wire slave device, the DS2482-800 is a 1-Wire master. Internal factory-trimmed timers relieve the system host processor from generating time-critical 1-Wire waveforms, supporting both standard and Overdrive 1-Wire communication speeds. To optimize 1-Wire waveform generation, the DS2482-800 performs slew-rate control on rising and falling 1-Wire edges and has a programmable feature to mask the fast presence pulse edge that some 1-Wire slave devices can generate. Programmable strong pullup features support 1-Wire power delivery to 1-Wire devices such as EEPROMs and sensors. The DS2482-800 combines these features with eight independent 1-Wire I/O channels. The I²C slave address assignment is controlled by three binary address inputs, resolving potential conflicts with other I²C slave devices in the system.
주요기능
애플리케이션/용도
I²C Host Interface, Supports 100kHz and 400kHz I²C Communication Speeds
1-Wire Master I/O with Selectable Active or Passive 1-Wire Pullup
Provides Reset/Presence, 8-Bit, Single-Bit, and Three-Bit 1-Wire I/O Sequences
Eight Channels of Independently Operated 1-Wire I/O
Standard and Overdrive 1-Wire Communication Speeds
Slew Controlled 1-Wire Edges
Selectable 1-Wire Slave Presence Pulse Falling Edge Masking to Control Fast Edges on the 1-Wire Line
Supports Low-Impedance 1-Wire Strong Pullup for EEPROMs, Temp Sensors, or Other 1-Wire Slaves That Have Momentary High Current Modes
Three Address Inputs for I²C Address Assignment
Wide Operating Range: 2.9V to 5.5V, -40°C to +85°C
필요한 것을 찾지 못하셨나요?
Maxim 애플리케이션 엔지니어에게 문의하십시오. 부품을 찾는데 필요한 전문가의 도움이 보통 업무일 1일 이내에 제공됩니다.
부품번호 suffix: T 또는 T&R = 테잎 앤 릴,
+ = RoHS/lead-free,
# = RoHS/lead 예외.추가 정보: 전체 데이터 시트 또는 부품번호 규칙
*일부 패키지는 크기 편차(variation)를 가지며 이 값은 도면 상에 제시되어 있습니다. “패키지 코드/편차”는 해당 제품이 사용하고 있는 편차를 보여줍니다. 부품번호 suffix에 "+", "#", "-"는 RoHS 준수 상태를 나타냅니다. 패키지 도면에 suffix 문자는 다를 수 있습니다.
다운로드
