The DS1482 is a simple 1-Wire® line driver with load sensor and level shifter, designed to function as an interface between a 3V host system and a 1-Wire system that runs on 5V. Two supplies are provided, a 5V supply for the 1-Wire operations (VCC) and an interface supply (VCCQ). The DS1482 can connect directly to a synchronous serial port if it supports the appropriate bit rates to generate 1-Wire timing.
Figure 1, of the full data sheet, shows the DS1482 block diagram. TXD is buffered and controls an N-channel transistor, which drives the 1-Wire pin I/O low, e.g., to initiate a time slot. The logic level of the I/O pin is returned through a level-shifting buffer to the RXD pin for the host processor to read. Figure 3, of the full data sheet, shows the relationship of these signals in case of a 1-Wire read time slot.
The SPU input generates a control signal (PCTLZ) for an external low-impedance PMOS transistor (Figure 2 of the full data sheet) that bypasses the 1-Wire pullup resistor (RPUP) to provide power for 1-Wire devices with a high-load current. PCTLZ is gated by the inverted TXD signal. This prevents a high through-current in case TXD and SPU are high at the same time.
The DS1482 contains a high-precision comparator because it is important for the host micro to know when the high load on the 1-Wire side is no longer active. As shown in Figure 4, of the full data sheet, the high current load causes a small drop of the voltage on the I/O pin. The comparator detects when the high current phase ends, and enables DONE after the deglitching time tCF is over. The START signal allows the host micro to selectively enable DONE.
주요기능
애플리케이션/용도
Works with All iButtons® and 1-Wire Devices
Communicates at Regular and Overdrive 1-Wire Speed (Host-Dependent)
Separate Interface Power Supply to Level Shift to Non-5V Systems
External Strong-Pullup Control Pin can be Used to Provide Low-On-Resistance-High Current Power Source
Load Sensor to Detect when Strong-Pullup Power Delivery is no Longer Needed
Power Delivery DONE Signal can be Connected to Host Interrupt
필요한 것을 찾지 못하셨나요?
Maxim 애플리케이션 엔지니어에게 문의하십시오. 부품을 찾는데 필요한 전문가의 도움이 보통 업무일 1일 이내에 제공됩니다.
부품번호 suffix: T 또는 T&R = 테잎 앤 릴,
+ = RoHS/lead-free,
# = RoHS/lead 예외.추가 정보: 전체 데이터 시트 또는 부품번호 규칙
*일부 패키지는 크기 편차(variation)를 가지며 이 값은 도면 상에 제시되어 있습니다. “패키지 코드/편차”는 해당 제품이 사용하고 있는 편차를 보여줍니다. 부품번호 suffix에 "+", "#", "-"는 RoHS 준수 상태를 나타냅니다. 패키지 도면에 suffix 문자는 다를 수 있습니다.
다운로드