This DS9503 is an ESD protection device for 1-Wire® interfaces. In contrast to the DS9502, the DS9503 includes two 5Ω isolation resistors on chip. Although 5Ω are negligible during communication, they represent a high impedance relative to the conducting diode during an ESD event. Thus, the diode absorbs the energy while the resistors further isolate and protect the circuit at the other side of the package. If used with circuits that already have a strong ESD-protection at their I/O port, the ESD protection level is raised to more than 27kV (IEC 801-2 Reference model). In case of abnormal ESD hits beyond its maximum ratings the DS9503 will eventually fail "short" thus preventing further damage.
During normal operation the DS9503 behaves like a Zener diode. When the voltage exceeds the trigger voltage, the I/V characteristic of the device will "snapback" allowing the same or higher amount of current to flow, but at a significantly lower voltage. As long as a minimum current or voltage is maintained, the device will stay in the "snapback mode." If the voltage or the current falls below the holding voltage or holding current, the device will abruptly change to its normal mode and conduct only a small leakage current.
주요기능
Zener characteristic with voltage snap-back to protect against ESD hits
High avalanche voltage, low leakage and low capacitance avoid signal attenuation
필요한 것을 찾지 못하셨나요?
Maxim 애플리케이션 엔지니어에게 문의하십시오. 부품을 찾는데 필요한 전문가의 도움이 보통 업무일 1일 이내에 제공됩니다.
부품번호 suffix: T 또는 T&R = 테잎 앤 릴,
+ = RoHS/lead-free,
# = RoHS/lead 예외.추가 정보: 전체 데이터 시트 또는 부품번호 규칙
*일부 패키지는 크기 편차(variation)를 가지며 이 값은 도면 상에 제시되어 있습니다. “패키지 코드/편차”는 해당 제품이 사용하고 있는 편차를 보여줍니다. 부품번호 suffix에 "+", "#", "-"는 RoHS 준수 상태를 나타냅니다. 패키지 도면에 suffix 문자는 다를 수 있습니다.
다운로드
