The DS21348 is a complete selectable E1 or T1 line interface unit (LIU) for short-haul and long-haul
applications. Throughout the data sheet, J1 is represented wherever T1 exists. Receive sensitivity adjusts
automatically to the incoming signal and can be programmed for 0dB to 12dB or 0dB to 43dB for E1
applications and 0dB to 30dB or 0dB to 36dB for T1 applications. The device can generate the necessary
G.703 E1 waveshapes in 75Ω or 120Ω applications and DSX-1 line build-outs or CSU line build-outs of
0dB, -7.5dB, -15dB, and -22.5dB for T1 applications. The crystal-less on-board jitter attenuator requires
only a 2.048MHz MCLK for both E1 and T1 applications (with the option of using a 1.544MHz MCLK
in T1 applications). The jitter attenuator FIFO is selectable to either 32 bits or 128 bits in depth and can
be placed in either the transmit or receive data paths. An X 2.048MHz output clock synthesized to RCLK
is available for use as a backplane system clock (where n = 1, 2, 4, or 8).
The DS21348 has diagnostic capabilities such as loopbacks and PRBS pattern generation/detection. 16-
bit loop-up and loop-down codes can be generated and detected. The device can be controlled through an
8-bit parallel muxed or nonmuxed port, serial port, or used in hardware mode. The device fully meets all
of the latest E1 and T1 specifications including ANSI T1.403-1999, ANSI T1.408, AT&T TR 62411,
ITU G.703, G.704, G.706, G.736, G.775, G.823, I.431, O.151, O.161, ETSI ETS 300 166, JTG.703,
JTI.431, JJ-20.1, TBR12, TBR13, and CTR4.
主な特長
Complete E1, T1, or J1 line interface unit (LIU)
Supports both long-haul and short-haul trunks
Internal software-selectable receive-side termination for 75Ω/100Ω/120Ω
3.3V power supply
32-bit or 128-bit crystal-less jitter attenuator requires only a 2.048MHz master clock for both E1 and T1 with option to use 1.544MHz for T1
Generates the appropriate line build-outs, with and without return loss, for E1 and DSX-1 and CSU line build-outs for T1
AMI, HDB3, and B8ZS, encoding/decoding
16.384MHz, 8.192MHz, 4.096MHz, or 2.048MHz clock output synthesized to recovered clock
Programmable monitor mode for receiver
Loopbacks and PRBS pattern generation/detection with output for received errors
Generates/detects in-band loop codes, 1 to 16 bits including CSU loop codes
8-bit parallel or serial interface with optional hardware mode
Muxed and nonmuxed parallel bus supports Intel or Motorola
Notes: **This pricing is BUDGETARY, for comparing similar parts. Prices are in
U.S. dollars and subject to change. Quantity pricing may vary
substantially and international prices may differ due to local
duties, taxes, fees, and exchange rates. For volume-specific prices
and delivery, please see the price and availability page
or contact an authorized distributor.
ダウンロードする
