Abstract: Relay-driver IC allows a 3-bit parallel interface to independently open or close each of four latching relays.
Single-coil latching relays, with applications in signal routing, audio, and automotive systems, can pose a design challenge because coil current must flow in both directions through a single coil. Current flowing in one direction latches the relay in its "set" position. Current in the opposite direction latches it in the "reset" position. The relay maintains its position even when the coil current is removed. Power is saved by removing coil current after the relay latches.
In Figure 1, current flowing from pin 1 to pin 8 latches the relay in the set position, while current from pin 8 to pin 1 resets it.
Figure 1. Current flow in a single coil latches the corresponding relay in its SET or RESET position.
A simple circuit that drives up to four single-coil latching relays (Figure 2) includes a parallel-interface relay driver (U1) with open-drain outputs (Figure 3) and inductive-kickback protection. Latch any of the four relays to its set or reset position by turning on the corresponding output (OUTX). That output is selected by asserting its digital address on pins A2-A0 while active-low CS is high. Activate the output by toggling active-low CS (Figure 4).
Figure 2. This circuit easily drives four single-coil latching relays.
Figure 3. U1's open-drain outputs, from Figure 2.
Figure 4. Interface timing for the circuit of Figure 2.
Current flows into the enabled open drain output and latches the relay to its set or reset position, according to the direction of coil current. Drive active-low RESET low to turn off all enabled open-drain outputs. Drive active-low RESET low as soon as the relays latch to ensure lowest power consumption. Observe the set/reset timing shown in Figure 4. Do not pull active-low RESET low until the required time (tSET/RESET) has elapsed. Waiting tSET/RESET after the last active-low CS toggle ensures that all selected relays will properly latch to their intended positions.
Clamping diodes on each OUTX pin catch high-voltage transients that occur when the coil current is interrupted. Those diodes (shown in Figure 2) clamp the OUTX voltage at VCC - 0.7V.
의견을 보내주세요! 위 내용이 도움이 되셨나요? 여러분의 의견을 기다립니다 — Maxim은 보내주신 정정이나 제안사항을 반영하고 있습니다.
이 페이지를 평가하고 의견을 보내주십시오.
다운로드, PDF 형식
